Setting up a breakpoint

Neven Has haski at sezampro.yu
Sat May 17 07:35:16 PDT 2003

On Thu, May 15, 2003 at 04:44:41PM -0600, Gerard Beekmans wrote:
> Another feature that might be handy would be setting a breakpoint.
> Say I needed to test a new chapter6-flex installation, I could tell
> the profile to build up to the package before flex and then take
> over by doing a manual test of a new flex package.

If stopping the execution at certain point is all you need, you can
always add <execute command="false"/> there.  I don't see any other
use for such breakpoint, or I'm just misunderstanding you?

> Maybe this could be done with my other question performing actions
> on only marked elements (marking up to but not including flex would
> and executing those elements would work).

Something other than s -> m (for starting only marked elements) does?


Unsubscribe: send email to listar at
and put 'unsubscribe alfs-discuss' in the subject header of the message

More information about the alfs-discuss mailing list