[blfs-support] Not able to start the Xorg.

me at pc-networking-services.com me at pc-networking-services.com
Wed Mar 26 18:39:51 PDT 2014


>
>
>
> Hi David,
>>Only one udevd can operate at the same time. No need to do anythingwith
>> udev. (You can use eudev too, scripts around udev do the logic,udev the
>> work.)
> ok i will not install the Udev given in the BLFS.
>>Please do install pciutils so we can see type of your VGA hardware.
> i have installed and the output of (/usr/sbin) lspci -v | grep VGA is
> 00:01.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI]
> Trinity [Radeon HD 7640G] (prog-if 00 [VGA controller])01:00.0 VGA
> compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] Thames
> [Radeon HD 7500M/7600M Series] (prog-if 00 [VGA controller])
>>For fglrx you should configure Xorg using vendor tool packed withdriver
>> package - fglrxconfig.For modern AMD driver it is called aticonfig.
> I used both the command "fglrxconfig" & "aticonfig" but it returned "bash
> command not found"
>
>> If it is laptop with two graphics cards you maybe will need PRIME
>> orBumblebee for switching it if it is not selectable in BIOS/UEFI.
> yes It is a laptop with dual graphics and it is proved by the lspci
> command above.
> And originally i din't installed the vesafb i just enabled it while kernel
> configuration.
>
>> Is kernel module for your card loaded? (lsmod) Does the modulerecognize
>> your card? (check your system log messages fileor rmmod module &&
>> modprobe module and post output of modprobe commandfrom
>> terminal/konsole.)
>>Did you identified the module for your VGA and tried that removal/insert?
> I think so it has been loaded. And secondly i don't know about which
> module to select can you please help and name them so that i can perform
> the operation and send you the log of it.
>
> in last i have some attachments.1. lsmod output after installation on
> Pciutils.2.output of command Xorg -configure 1> a.log 2> w.log3.I also
> performed Xorg -config xorg.conf.d -retro( but it is just getting stuck at
> the last line as given in the file, i am able to enter words but it does
> not respond to it.)
> (and i would also like to mention that their is no files in xorg.conf.d)
>
>  		 	   		  --
> http://linuxfromscratch.org/mailman/listinfo/blfs-support
> FAQ: http://www.linuxfromscratch.org/blfs/faq.html
> Unsubscribe: See the above information page

Hello,

Make sure that you have installed:
Xorg Nouveau Driver-1.0.10
Xorg ATI Driver-7.3.0
MesaLib-10.0.3

Mesalib is required for compiling the driver for your graphics chip set.

When compiling Mesa be sure that you do not remove anything from the
configure line that is shown on the instruction page as they are needed to
compile your driver.

Mesa will need to be compiled first (if its not already installed).

By having both of the AMD chip set drivers installed your computer has
more chance of being able to switch properly to the graphics mode as it
has a fall back.

Also it may well pay to install Xorg VESA Driver-2.3.3 as this one will be
used if both of the others fail.

Regards,

Christopher




More information about the blfs-support mailing list