[lfs-support] Unable to build File-5.11
Rabi Shanker Guha
guha.rabishankar at gmail.com
Sat Jan 19 00:04:55 PST 2013
Yes I Ctrl+C'ed it but thats because it got stuck after
checking for gzopen in -lz... yes
and it remained in that state for almost 30 mins and I can confirm there
wasnt any config.status generated.
On Sat, Jan 19, 2013 at 2:43 AM, Pierre Labastie <pierre.labastie at neuf.fr>wrote:
> Le 18/01/2013 20:55, Rabi Shanker Guha a écrit :
> > Hello,
> > Im building the LFS system. However I seem to be stuck on section 6.12
> > (Installing File 5.11)
> > When I run ./configure --prefix=/usr, the configure script stops after
> > the following lines:
> > checking for strlcpy... no
> > checking for strlcat... no
> > checking for getline... yes
> > checking for gzopen in -lz... yes
> Those are normally the last line of the "checking" part. Then should
> come the "config.status" part:
> configure: creating ./config.status
> config.status: creating Makefile
> config.status: creating src/Makefile
> config.status: creating magic/Makefile
> config.status: creating tests/Makefile
> config.status: creating doc/Makefile
> config.status: creating python/Makefile
> config.status: creating config.h
> config.status: executing depfiles commands
> config.status: executing libtool commands
> and that's it...
> According to config.log, you had to interrupt the script (signal 2),
> hadn't you? Or did you inadvertently type Ctrl-C?
> Another possibility is that you typed Ctrl-S (this stops output).
> I have no idea why configure would stop before creating config.status.
> FAQ: http://www.linuxfromscratch.org/lfs/faq.html
> Unsubscribe: See the above information page
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the lfs-support